Testo Saveris Stub Probe 0628 7510
- -20 to +70 °C
- Air Temperature Probe
- Liquids & Pastes Probe
- Rated IP54
- General purpose probe
- High Accuracy
- Temperature Measurement
-
-
Information on the calibration of newly purchased equipment and what it means to you.
Calibration and its certification comes in varying forms on new equipment and in this section, we will break it down into the three areas that we use to classify calibration state at the point of purchase.
Manufacturers Calibration Certificate
This is a calibration certificate offered by the manufacturer supplied with the tester. This is also known as an end-of-line certificate or manufacturer’s certificate. These certificates vary depending on the manufacturer and product. They will not have your company's name on them and don’t always show proven test results.
Where applicable we will include the following statement relating to the item/s on the products page under the heading *Important Calibration Information.
This instrument comes complete with the manufacturer's calibration certificate. Please be aware that these certificates are generic and may also be time-lapsed.
If you would prefer a personalised full traceable calibration certificate applied to the equipment before dispatch, then please select this option from the drop-down menu above, an additional calibration charge will apply.Manufacturers Certificate of Conformity
A manufacturer's certificate of conformity is not a calibration certificate. It is merely a statement that the equipment has been produced to operate within its intended application, it has no traceable certificate or constitutes any defined results for accuracy before leaving the manufacturing process.
Where applicable we will include the following statement relating to the item/s on the products page under the heading *Important Calibration Information.
This instrument comes with a ‘manufacturer's certificate of conformity’. It is important to understand that this does NOT constitute a ‘calibration certificate’. A certificate of conformity merely states that the equipment has been designed and produced to meet the requirements of its intended application.
Where calibration of an instrument is possible we will offer this as a separately purchasable item and may be selected from the drop-down box above. You will be sent a full traceable calibration certificate produced in our laboratory and applied with your details as required.Personalised traceable calibration certificate from isswww
This is a calibration certificate created by us at ISS. This certificate is fully traceable to national and international standards. The certificate will show your company's details, tester information, proven test results and the equipment used to carry out the test. Nearly 90% of all calibrations we do are done in-house in one of our many fully equipped laboratories. You can add this service to your order on the product page before you checkout.
Where applicable we will include the following statement relating to the item/s on the products page under the heading *Important Calibration Information.
We are on occasion able to offer FREE calibration on certain products at their point of sale (newly purchased equipment only) please look out for the following badge on the product's page to take advantage of this free offer.
-
-
Testo Stub Probe 0628 7510
*Suitable for use with the Testo Saveris 2 T2 Temperature Data Logger
Key Features:
- NTC temperature probe with short probe tube (stub probe)
- Thermistor NTC temperature probe with short probe tube (stub probe)
- Measuring range: -4 to 158 °F (-20 to +70 °C)
The Testo stub probe is suitable for air temperature measurements and also for temperature measurement in liquids and pastes. Because of the NTC sensor element, the probe provides precise temperature measurements with an accuracy of up to ±0.2 °C/F.
The temperature probe features a rounded tip with a short probe tube, is 35 mm in length. With this probe you are ideally equipped for measuring temperatures in close proximity to the testo Saveris 2-T2 Wi-Fi data logger, with no probe cable required.
Protection class IP 54 means that the stub probe is splash-proof.
The stub probe is rated protection class IP 54 (splash-proof).
The perfect probe for any application
If you don't see an appropriate temperature probe for your application, please contact us directly. We have a large range of standard and custom temperature probes.
*For air temperature measurements, the response time is about 40 – 60 times higher than the indicated value measured in water. If you should require a slow-response temperature probe to measure air temperature, this probe is particularly appropriate because it does not take brief temperature peaks into account, or only to a very small degree, when measuring temperature. For example, if you are planning to use this probe to measure air temperature in the refrigerator, briefly opening the refrigerator door would not take into account the temperature fluctuation which results from mixing the warm room temperature with the refrigerator temperature.
If you need an air temperature probe with a fast response time, your best choice would be the exceptionally fast temperature probe 0602 0493 which has a large measuring range. This temperature probe can be connected to the testo Saveris 2-T3 Wi-Fi data logger.
| Key Features | -20 to +70 °C, Air Temperature Probe, Liquids & Pastes Probe, Rated IP54, General purpose probe | ||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Product Stock Status | Next Day Delivery (subject to availability) | ||||||||||||||||||||||||
| Manufacturer | Testo | ||||||||||||||||||||||||
| Short Description | Temperature - NTC
Updated January 2024
Please note, our cut-off time is 2:00pmOrders requiring calibrationWhilst we take the greatest care to get all orders dispatched and delivered to you in the stated time frame, orders received PM and requiring calibration may on occasion miss dispatch that day, according to the complexity of the calibration.Be assured they will ship on the next dispatch this in most cases should not add more than 24 hours to your delivery. Bank/Public HolidaysPredicted delivery times are based on regular trading days Monday to Friday. Public holidays, bank holidays and weekends are outside the usual scopeof our dispatch and subject to activities/holidays of our carriers and therefore may incur additional days lead time to your order. *UK Mainland (Revised March 2021)
Delivery SurchargesBecause of the high cost of carriage, we regretfully need to apply a surcharge on all deliveries made in the following regions:
Offshore ServicesAll offshore deliveries are a 3-4 day service as standard. This includes Channel Islands, Northern & Southern Ireland, Scottish Islands, Isle of Man and the Scilly Isles. International deliveryInternational delivery charges are automatically added to your order at the checkout. For any questions regarding international deliveries please contact us at sales@isswww.co.uk ExportAll export inquiries should be directed to the export division before placement of order. If no shipping option is available to your selected country please call us FREE on 0800 0224 060 to discuss your requirements.
|
